What is the best method to heat test before pinning
- Thread starter costatoyz
- Start date
Honestly bro, I would just run it under hot water from a sink. That's more than adequate to heat it up enough for injection
![[9oNe6]BillyD@kid](/forums/data/avatars/m/2/2076.jpg?1477587594){kind=avatar}
^I don't heat my compounds before pinning, but u can run it under hot water or us a heat pad
Same as Rick and NY... safe and easy.
Sent from my Q10 using Tapatalk
Sent from my Q10 using Tapatalk
Honestly I never heat mine either, but that method will work well for those that want to
Ol.DirtyBastard
Senior Member
Ive used a cereal bowl or shot glass with about 1/3" of water....nuke for 10-20 seconds. While I prep for the shot, I put the vial in the water. By the time Im ready to draw, the solution is watery and it smooth as butter....no pip.
But thats just me.....
My tren ace was thick, so thats what I did to "soften" it up; so to speak
But thats just me.....
My tren ace was thick, so thats what I did to "soften" it up; so to speak
Jake
Active member
Dude-pip has nothing to do with temp of gear. Heating only allows quicker in and out. If you pull up with an 18g.. it is quicker than heated gear pulled up with a 25g pin .I do not see what you are getting at. I keep my gear in my garage during the summer and it is not temp controlled. So the gear is warm. Are you keeping your gear in the fridge or something. Whatever you are thinking I can promise pip is not in the equation. I pull with an 18 and shott with a 22. If the 22 scares you then pull with an 18 and shoot witha 25g. As long as your gear is room temp I do not see a problem
Yes, I didn't elaborate but this is absolutely 100% true. Heating gear makes for easier oil flow through the needle, but has nothing to do with PIP whatsoever. It can be hard to push oil through a 25g but it's still what I use, and do not heat the oil at all. Just requires a little more pressure on the plunger
Ol.DirtyBastard
Senior Member
Good point.....could be carrier oil. Or even gauge size, technique...etc...
Ive just had better success heating a tad to loosen up viscosity...it helps
drb_iac
Active member
How come you want to heat it lil bro?
It aint some of that 400 shit is it?
C
cbbram00
Guest
I used a 25g with Deca for the first time last night and I didn't have any problems at all. Smoooooootttthhhhhhhh.....
I agree. I have deca from Platinum from Pharma Lady and it is just as smooth as my pharmacy test. It is a little weird though. Takes longer to draw but not longer to inject.
Sent from my iPhone using Tapatalk
C
cbbram00
Guest
I had the same experience... It kinda trickled out of the vial but injected very smooth.
C
cbbram00
Guest
I don't do anything except clean it with alcohol...
Well... Occasionally I tell the vial "I love you"... Lol
Well... Occasionally I tell the vial "I love you"... Lol
Good to hear. Starting biotech Deca in 3 weeks, and plan to use 25g
Heating or not depends on the needle size, the temperature in which is stored, and the density of the product. I used a 25g for sustenon 350ml/mg at room temperature and it still took its time to get into the pen. Some uses a bigger needle to get it out and then a small to inject. Just see yourself how easily comes out and play around with temperature and or needle size.
